[英文] 01 Basic Solid-State Physics: Energy bands, Electrons and Holes|完整英文原声在后半部
[中文] 02 固体物理基础:掺杂、载流子浓度与分布
[中文] 06 双极型晶体管:基本工作原理与电流特性
[中文] 07 双极型晶体管:厄利效应、Ebers-Moll模型与大信号模型
[中文] 08 MOS电容:能带图、积累、耗尽、反型与阈值电压
[中文] 09 MOSFET入门:阈值电压、体效应与线性区IV特性
[中文] 10 MOSFET IV特性推导、工作区与沟道长度调制
[中文] 11 MOSFET夹断时的沟道电荷与沟道电容计算
[中文] 12 速度饱和与短沟道效应:SOI、FinFET、Pillar FET、应变硅
[中文] 15 小信号模型:MOS与BJT对比、跨导
[中文] 16 小信号模型:输入输出电阻、电容与截止频率
[中文] 17 电路与网络理论概览:节点分析与常用定理
[中文] 19 放大器基础(上):MOS、BJT与任意三端器件、最大增益
[中文] 20 放大器基础(下):MOS、BJT与任意三端器件、最大增益
[中文] 21 BJT放大器(上):射极退化、传输特性与增益
[中文] 22 BJT放大器(下):射随器、共基、共射共基、有源负载
[中文] 23 MOS放大级(上):源极退化、输入输出阻抗
[中文] 24 MOS放大级(下):共漏、共栅、级联与提升增益
[中文] 25 双管放大级:级联、折叠共源共栅、有源负载、达林顿与电流镜
[中文] 26 差分信号与差分对:核心概念与BJT大信号特性
[中文] 27 差分放大器(上):MOS、BJT与任意三端器件
[中文] 28 差分放大器(下):MOS、BJT与任意三端器件
[中文] 29 带有源负载的差分放大器:差分转单端
[中文] 39 高频特性:传递函数、低通与高通响应
[中文] 42 一阶系统零极点与阶跃响应:下冲与过冲
[中文] 44 零值时间常数与传输常数ZVT:b1与a1项计算
[中文] 45 用ZVT估算带宽:高频放大器设计实例
[中文] 51 TTC实例:二阶系统、品质因数与自然频率
[中文] 52 TTC实例:负阻、振荡器与RLC电路
[中文] 53 基本放大级高频特性的TTC分析:CS、CE、CD、CC、CG、CB
[中文] 54 非耦合时间常数、独立零极点与可观测动态
[中文] 55 低截止频率估算:无穷值时间常数IVT
[中文] 56 分立与集成的差异:IVT低截止频率估算实例
[中文] 57 宽带放大器:增益带宽积与每级最优增益
[中文] 58 反馈:渐近传递函数、一阶分析与快速设计
[中文] 59 反馈动态:前向与反馈通路的频率影响、灵敏度降低
[中文] 61 回归比、渐近增益公式与直接前向传输
[中文] 62 有源反馈、双反馈环路与回归比的源依赖性实例
[中文] 63 反馈下的端口阻抗:Blackman公式
[中文] 67 稳定性判据:Routh-Hurwitz与Nyquist推导
[中文] 68 非线性稳定性判据:圆判据与离轴圆判据
[中文] 70 反馈放大器补偿:一阶、二阶、三阶系统概览
[中文] 71 电路补偿技术:单级与两级运放、米勒补偿
[中文] 72 随机变量概览:功率谱密度、自相关与互相关
[中文] 73 热噪声:物理机制、频谱、KT/C噪声与可用噪声功率
[中文] 74 散粒噪声、爆裂噪声、闪烁噪声与雪崩噪声
[中文] 75 PN结二极管、双极型晶体管与MOS管的噪声模型
[中文] 76 放大器噪声入门:输出噪声与输入参考噪声
[中文] 77 输入参考噪声:二端口噪声模型与共射极
[中文] 78 基本放大级噪声:输入参考噪声随频率变化、Friis公式
[中文] 84 振荡器通用拓扑:大信号Gm、振幅与频率计算
[中文] 90 电路中的时间常数与传输常数(高频电路分析专题)
[英文] 02 Basic Solid-State Physics: Doping, Carrier Density, Distribution
[英文] 03 Carrier Movement in Semiconductors, Drift and Diffusion
[英文] 04 PN Junction, Depletion Region, Diode Equation
[英文] 05 PN Junction, Junction Capacitance, Doping Profile
[英文] 06 Bipolar Junction Transistor, basic operation, current flow prope
[英文] 07 Bipolar transistor: Early effect, Ebers-Moll model, large-signal
[英文] 08 MOS Capacitor: Energy band diagram, accumulation, depletion, and
[英文] 09 MOSFET Introduction, threshold and body effect, IV characteristi
[英文] 10 MOSFET IV Characteristics Derivation, Regions of Operation, Chan
[英文] 11 MOSFET Channel charge in pinch-off, Channel capacitance calculat
[英文] 12 Velocity saturated MOSFETs, short channel effects, SOI, FinFET,
[英文] 13 MOSFET Sub-threshold behavior
[英文] 14 Kelvin Generator, water FET, positive feedback.
[英文] 15 Small-signal model, MOS vs. BJT, core transistor behavior, trans
[英文] 16 Small-signal model, MOS vs. BJT, input and output resistance, ca
[英文] 17 Circuit and network theory brief overview, nodal analysis, theor
[英文] 18 Economics of Integrated Circuits, Yield, Pricing
[英文] 19 (Pt.1) Amplifier Fundamentals, MOS, BJT, and ATD (arbitrary 3-te
[英文] 20 (Pt.2) Amplifier Fundamentals, MOS, BJT, and ATD (arbitrary 3-te
[英文] 21 (Pt. 1) BJT Amplifier, Emitter Degeneration, Transfer characteri
[英文] 22 (Pt. 2) BJT Amplifier, Emitter follower, common-based, cascode,
[英文] 23 (Pt. 1) MOS amplifier stages: Source degeneration, input and out
[英文] 24 (Pt. 2) MOS amplifier stages: common-drain, common-gate, cascade
[英文] 25 Two transistor stages: cascade, folded cascade, active load, Dar
[英文] 26 Differential Signaling and differential pair: core concept and l
[英文] 27 (Pt. 1) Differential Amplifiers: MOS, BJT, and ATD
[英文] 28 (Pt. 2) Differential Amplifiers: MOS, BJT, and ATD
[英文] 29 Differential amplifier with active load. Differential-to-single-
[英文] 30 MOS Differential-to-Single-Ended Conversion. Gain Enhancement
[英文] 31 Basic Biasing Concepts
[英文] 32 Integrated circuit biasing, current mirrors, headroom
[英文] 33 Process, Supply, and Temperature Independent Biasing
[英文] 34 Scaled bandgap reference, adjustable voltage PVT independent ref
[英文] 35 Driver stages, output stages, Class A and Class B
[英文] 36 Op-Amp Design: Basic MOS Op-Amp
[英文] 37 MOS Op-Amp Design Examples
[英文] 38 BJT Op-Amp Design Example
[英文] 39 High frequency: transfer functions, lower pass and high pass res
[英文] 40 Time- and transfer-constants in 1st order system
[英文] 41 1st Order high-frequency TTC analysis of common source and commo
[英文] 42 Zero/pole in 1st order system, step response, undershoot and ove
[英文] 43 Miller multiplication and effect, input impedance of common-sour
[英文] 44 Zero-value time and transfer constants (ZVT), b1 and a1 term cal
[英文] 45 Bandwidth estimation using ZVT, High-frequency Amplifier design
[英文] 46 When ZVT bandwidth estimation fails
[英文] 47 Taking zeros into account in ZVT bandwidth estimate
[英文] 48 Creation of zeros: series RC branch in parallel
[英文] 49 Creation of zeros: parallel signal paths
[英文] 50 Generalized Time- and Transfer constants; higher order terms
[英文] 51 TTC Examples, 2nd Order System, Quality Factor and Natural Frequ
[英文] 52 TTC Examples, negative resistance, oscillator, RLC circuit
[英文] 53 High Frequency behavior of basic amplifier stages (CS, CE, CD, C
[英文] 54 Uncoupled time-constants, independent poles and zeros, observabl
[英文] 55 Low Cut-off Frequency Estimation, Infinite value time-constants
[英文] 56 Discrete vs. Integrated Variations, Low Cut-Off Estimation with
[英文] 57 Broadband amplifiers, gain-bandwidth product, optimum gain per s
[英文] 58 Feedback: Asymptotic Transfer Function, 1st Order Analysis, Rapi
[英文] 59 Feedback dynamics, forward and feedback path frequency effect, f
[英文] 60 Effect of Feedback on Nonlinearity
[英文] 61 Return Ratio, Asymptotic Gain Formula, Direct forward transfer
[英文] 62 Active feedback, dual feedback loop, Source dependence of return
[英文] 63 Port Impedance under Feedback, Blackman Formula
[英文] 64 Unilateral Loop gain, voltage and current loop gains
[英文] 65 Bilateral loop gain, derivation, feedback
[英文] 66 Instability and conditional stability, circuit examples.
[英文] 67 Stability criteria: Routh-Hurwitz, Nyquist derivation
[英文] 68 Nonlinear stability criteria: Circle criterion, off-axis circle
[英文] 69 Phase margin and gain margin
[英文] 70 Feedback amplifier compensation, general view for 1st, 2nd, and
[英文] 71 Circuit compensation techniques, one- and two-stage op-amp, Mill
[英文] 72 Overview of random variable, PSD, auto- and cross-correlation
[英文] 73 Thermal white noise physics, properties, and spectrum, KT/C nois
[英文] 74 Shot noise, burst noise, flicker(1/f) noise, avalanche noise
[英文] 75 Noise models for pn-junction diode, bipolar transistor, and MOS
[英文] 76 Intro. to amplifier noise, output noise, and input-referred nois
[英文] 77 Input-referred noise, 2-port noise model, common-emitter
[英文] 78 Noise behavior of basic stages, input-referred noise vs. frequen
[英文] 79 Intro to comparators and offset cancellation
[英文] 80 Latch dynamics, latched comparator
[英文] 81 Intro to data converters metrics, basic DAC
[英文] 82 Basic digital-to-analog converter architectures
[英文] 83 Basic analog-to-digital converter architectures
[英文] 84 Oscillator general topology, large signal Gm, amplitude and freq
[英文] 85 Phase noise in oscillators (introduction)
[英文] 86 Oscillator design, noise shifting oscillator example
[英文] 87 Intro. to phase-locked loops (PLL) noise
[英文] 88 Intro. to RF power amplifiers
[英文] 89 Brief course summary
[英文] 90 Time and Transfer Constants in Circuits (High Frequency Circuit
[英文] 91 Feedback Circuit Analysis and Design (Overview)